Affordable Access

Additive metallurgy - Thermal influences on structure and properties of stainless steel 316L

Authors
  • Olsén, Jon
Publication Date
Jan 01, 2020
Source
DiVA - Academic Archive On-line
Keywords
Language
English
License
Green
External links

Abstract

Additive manufacturing (AM) as a manufacturing process has, in recent years, become widely accepted as capable of manufacturing parts that will be used in end products. In this thesis, stainless steel grade 316L parts are manufactured using two different powder bed fusion techniques, selective laser melting (SLM) and electron beam melting (EBM). It is recognized that parts made using these processes will have unique microstructures and mechanical properties that have not been seen in bulk parts produced with other methods. The driving force behind the formation of these structures is the fast cooling speed that induces segregation of elements, forming an inhomogeneous microstructure. How these structures react to thermal treatment is less well known and an essential aspect in many applications. Parts manufactured using SLM was treated with hot isostatic pressing (HIP) to investigate if the material retains its unique features. Two different HIP cycles were used, one with 1150 °C and one with 1040 °C. In both cases, the cellular sub-grain structure fades. The cycle utilizing the high temperature is found to coarsen the grain structure and thus lowering the mechanical properties significantly. As manufactured parts show yield strength (615±1 MPa), tensile strength (725±2 MPa) and microhardness (211±10 Hv), compared to values of yield strength (284±2 MPa), tensile strength (636±1 MPa) and microhardness (178±8 Hv) after 1150 °C HIP. Using HIP at 1040 °C, the material will retain a finer grain structure resulting in higher yield strength (417±7 MPa) compared to 1150 °C HIP temperature, while the UTS and hardness have a similar value. It is also observed that the dispersed inclusions formed during SLM are still present after HIP to increase the mechanical properties compared to a conventionally annealed bar (TS: 515 MPa, YS: 205 MPa). Samples manufactured using EBM was investigated to understand the influence of the in-situ heat treatment that is present in the EBM process. The material possesses a long-range heterogeneous structure in addition to the cellular structure, where the cellular structure is present at the top and disappears further down the sample. Samples with different geometries were produced to study the effect of heat flux, cooling speed and the elevated temperature of 800 °C that is present during the EBM process. The thickness of the cell boundaries is measured in different areas, revealing that geometry and size of manufactured parts have a significant impact on the evolving microstructure. It is also revealed that the tensile strength (562±4 MPa) and microhardness (161±11 Hv) is not affected by the change in microstructure, resulting in a very homogeneous material concerning these parameters. Heat treating the material at 800 °C show that the cellular structure becomes diffuse after several hours, but the grain morphology stays the same. / <p>At the time of the doctoral defense, the following papers were unpublished and had a status as follows: Paper 5: Manuscript. Paper 6: Manuscript.</p>

Report this publication

Statistics

Seen <100 times