Affordable Access

Determination of membrane properties for use in the modelling of a membrane distillation module

Publication Date


Membrane distillation carried out in a counter current flow module, in which latent heat is recovered by heating the incoming cold seawater with the condensing product water flow, is a promising technology for low cost seawater desalination. The membranes used in this module are hydrophobic (polypropylene, polyethylene) and highly permeable fibre membranes. For modelling purposes the Knudsen diffusion and viscous flow membrane characteristics (K0 and B0 respectively) of five fibre membranes are determined. This paper presents a new, specially developed method for the determination of K0 and B0 values of highly permeable fibre membranes with single gas permeation experiments through a short dead end fibre. In order to be able to make use of a reliable method to determine the values of K0 and B0, it is essential that the pressure inside the permeable part of the membrane is constant. To determine the conditions at which the pressure drop in the permeable part of the membrane fibre is negligible, this part is reduced in length until the values of K0 and B0 become constant. For all membranes the gases He, N2 and CO2 were used. The gases N2 and CO2 lead to consistent values of K0 and B0. Helium gives less accurate results due to its low molecular weight. The three polypropylene membranes have a similar structure and have therefore about the same values for K0 and B0. The same was found for the two polyethylene fibres.

There are no comments yet on this publication. Be the first to share your thoughts.