Affordable Access

Power Efficient Gigabit Communication Over Capacitively Driven RC-Limited On-Chip Interconnects

Publication Date
  • Communication
  • Design


Abstract—This paper presents a set of circuit techniques to achieve high data rate point-to-point communication over long on-chip RC-limited wire-pairs. The ideal line termination impedances for a flat transfer function with linear phase (pure delay) are derived, using an s-parameter wire-pair model. It is shown that a driver with series capacitance on the one hand and a resistive load on the other, are fair approximations of these ideal terminations in the frequency range of interest. From a perspective of power efficiency, a capacitive driver is preferred, as the series capacitance reduces the voltage swing along the line which reduces dynamic power consumption. To reduce cross-talk and maintain data integrity, parallel differential interconnects with alternatingly one or two twists are used. In combination with a low offset dynamic sense amplifier at the receiver, and a low-power decision feedback equalization technique with analog feedback, gigabit communication is demonstrated at very low power consumption. A point-to-point link on a 90 nm CMOS test chip achieves 2 Gb/s over 10 mm long interconnects, while consuming 0.28 pJ/bit corresponding to 28 fJ/bit/mm, which is much lower than competing designs.

There are no comments yet on this publication. Be the first to share your thoughts.


Seen <100 times