Corley-Wiciak, Cedric (author) Richter, Carsten (author) Zoellner, Marvin H. (author) Zaitsev, Ignatii (author) Manganelli, Costanza L. (author) Hendrickx, N.W. (author) Sammak, A. (author) Veldhorst, M. (author) Scappucci, G. (author)
A strained Ge quantum well, grown on a SiGe/Si virtual substrate and hosting two electrostatically defined hole spin qubits, is nondestructively investigated by synchrotron-based scanning X-ray diffraction microscopy to determine all its Bravais lattice parameters. This allows rendering the three-dimensional spatial dependence of the six strain ten...
Dejea, Hector Schlepütz, Christian M. Méndez-Carmona, Natalia Arnold, Maria Garcia-Canadilla, Patricia Longnus, Sarah L. Stampanoni, Marco Bijnens, Bart Bonnin, Anne
Published in
Frontiers in Cardiovascular Medicine
Introduction Cardiac architecture has been extensively investigated ex vivo using a broad spectrum of imaging techniques. Nevertheless, the heart is a dynamic system and the structural mechanisms governing the cardiac cycle can only be unveiled when investigating it as such. Methods This work presents the customization of an isolated, perfused hear...
Dolan, Connor J Cakan, Deniz N Kumar, Rishi E Kodur, Moses Palmer, Jack R Luo, Yanqi Lai, Barry Fenning, David P
Published in
Journal of Physics D: Applied Physics
Understanding the optoelectronic properties of optically active materials at the nanoscale often proves challenging due to the diffraction-limited resolution of visible light probes and the dose sensitivity of many optically active materials to high-energy electron probes. In this study, we demonstrate correlative synchrotron-based scanning x-ray e...
Victor-Lovelace, Tiffany W Miller, Lisa M
Published in
Metallomics : integrated biometal science
X-ray fluorescence microscopy (XFM) has become a widely used technique for imaging the concentration and distribution of metal ions in cells and tissues. Recent advances in synchrotron sources, optics, and detectors have improved the spatial resolution of the technique to
Spiers, Kathryn M Brueckner, Dennis Garrevoet, Jan Falkenberg, Gerald van der Ent, Antony
Published in
Metallomics : integrated biometal science
Visualizing the endogenous distribution of elements within plant organs affords key insights in the regulation of trace elements in plants. Hyperaccumulators have extreme metal(loid) concentrations in their tissues, which make them useful models for studying metal(loid) homeostasis in plants. X-ray-based methods allow for the nondestructive analysi...
Liang, Xiaoying Beltran, Chris Liu, Chunbo Shen, Jiajian Bues, Martin Furutani, Keith M.
Published in
Frontiers in Oncology
Purpose To investigate the beam delivery time (BDT) reduction due to the improvement of machine parameters for Hitachi synchrotron-based proton PBS system. Methods BDTs for representative treatment plans were calculated to quantitatively estimate the BDT improvement from our 2015 system at Mayo Clinic in Arizona to our system to be implemented in 2...
Loron, Corentin Sforna, MC Borondics, F. Sandt, C. Javaux, Emmanuelle
peer reviewed
Abe, S. Aguasca-Cabot, A. Agudo, I. Crespo, N. Alvarez Antonelli, L.A. Aramo, C. Arbet-Engels, A. Artero, M. Asano, K. Aubert, P.
...
LHAASO J2108+5157 is one of the few known unidentified Ultra-High-Energy (UHE) gamma-ray sources with no Very-High-Energy (VHE) counterpart, recently discovered by the LHAASO collaboration. We observed LHAASO J2108+5157 in the X-ray band with XMM-Newton in 2021 for a total of 3.8 hours and at TeV energies with the Large-Sized Telescope prototype (L...
Morenas, M.
ALTIROC2 is a 225-channel ASIC designed in CMOS 130 nm to read out a 15 × 15 matrix of 1.3 mm × 1.3 mm Low Gain Avalanche Diodes (LGAD) for the ATLAS HGTD (High Granularity Timing Detector). The targeted combined time resolution of the sensor and its readout electronics range from 35 ps/hit (initial) to 65 ps/hit (end of operational lifetime). Each...
Fu, Y. (author)
When high-temperature steels are loaded under under industrially relevant conditions not only creep (i.e. a time dependent strain increase even under nominally constant loading conditions) occurs, but also local damage is formed. At relatively short exposure times quasi-spherical micron-sized cavities form preferentially at the grain boundaries ori...