This paper presents experimental studies on the compressive behavior of a sustainable steel-fiber reinforced composite bar (SFCB) under uniaxial compressive loading. The SFCB, combined with steel and fiber reinforced polymer (FRP), is expected to significantly enhance structural safety and sustainability. A new test method with LVDT and extensomete...
Time sequences of 3D images of an Al-Cu alloy in the mushy state are obtained using in situ and real-time X-ray microtomography during a tensile test. Surface meshes of phase interfaces are built from these images with the help of a Marching Cubes algorithm. The signed distance to the surface meshes is then computed on a finite element mesh of the ...
Several carbon-black filled styrene-butadiene rubbers showed different sensibilities to the Mullins softening when submitted to cyclic uniaxial tension. In order to quantify this softening, a damage parameter was introduced. It is defined by using a classic damage approach and can be estimated by using either the strain amplification factor method ...
Crack-free GaN epitaxial layer was obtained through inserting 80 nm graded AlGaN buffer layer between GaN epilayer and high temperature AlN buffer on 2-in Si(111) substrates by metal organic chemical vapor deposition. This paper investigated the influence of AlGaN buffer thickness on the structural properties of the GaN epilayer. It was confirmed f...
We studied the influence of high temperature AlN buffer thickness on the property of GaN film on Si (1 1 1) substrate. Samples were grown by metal organic chemical vapor deposition. Optical microscopy, atomic force microscopy and X-ray diffraction were employed to characterize the samples. The results demonstrated that thickness of high temperature...
Several thousands electrical connections are necessary in airplanes. Electrical cables are joined to contacts using manual crimping devices in industrial plants. When mechanical defects appear, the replacement of the defective connections has to be made directly on the airplane. This operation is difficult and time-consuming due to reduced accessib...
Many finite element programs including standard commercial software such as ABAQUS use an incremental finite strain formulation that is not fully work-conjugate, i.e., the work of stress increments on the strain increments does not give a second-order accurate expression for work. In particular, the stress increments based on the Jaumann rate of Ki...