Grauberger, Patric Eisenmann, Matthias Stoitzner, Julian Matthiesen, Sven
Published in
SN Applied Sciences
AbstractThis study presents an approach for identification and elimination of challenges in modelling in embodiment design. These challenges can be caused either by the modelling method or the corresponding training course. To investigate the efficacy of a modelling method, first challenges of the corresponding training course need to be addressed....
Geitenbeek, Romy (author)
Last mile delivery is often seen as bottleneck for delivery service growth: it is the most costly and highest polluting segment of the delivery supply chain. By integrating delivery robots in society, last mile delivery can be automatize to create a more cost and time efficient and sustainable delivery service. This also applies to the grocery deli...
Matthiesen, Sven Grauberger, Patric Bremer, Frank Nowoseltschenko, Konstantin
Published in
SN Applied Sciences
In product development, many different models of the product and the development process exist. In the phase of embodiment design, models of the product are essential. Finding a suitable product model for an embodiment design task can be challenging, because many different models are available. The aim of this contribution is to categorize existing...
Casner, Didier Houssin, Remy Renaud, Jean Knittel, Dominique
Objective: This paper deals with the design and the optimization of mechatronic devices. Introduction: Comparing with existing works, the design approach presented in this paper aims to integrate optimization in the design phase of complex mechatronic systems in order to increase the efficiency of this method. Methods: To solve this problem, a nove...
Casner, Didier Houssin, Rémy Renaud, Jean Knittel, Dominique
This paper deals with the embodiment design of mechatronic product and is intended for proposing a novel design support framework based on multiobjective optimization approaches. This framework builds design architectures by aggregating solution principles presented within a morphological matrix. Then, the solution principles are analyzed against c...
Warniez, Aude
L’intégration des systèmes mécatroniques est la source première de leur complexité de conception. Trois principaux types d’intégration sont en cause : l’intégration multi-domaine qui vise à intégrer en synergie la mécanique, l’électronique, l’informatique et l’automatique ; l’intégration multi-niveau prenant en compte les interfaces entre les diffé...
Cardillo, Alessandro Cascini, Gaetano Frillici, Francesco Saverio Rotini, Federico
Published in
Engineering with Computers
In a recent project the authors have developed an approach to assist the identification of the optimal topology of a technical system, capable of overcoming geometrical contradictions that arise from conflicting design requirements. The method is based on the hybridization of partial solutions obtained from mono-objective topology optimization task...
Collignan, Arnaud
En conception de produits, l'étape de conception dite architecturale doit aboutir à une solution décrivant les caractéristiques du produit, telles que les dimensions ou le choix de composants. Parmi les nombreuses solutions potentielles, il est nécessaire d'effectuer un choix et de pouvoir le justifier de manière rigoureuse. Ce choix doit en outre ...
Sébastian, P. Chenouard, R. Nadeau, J. -P. Fischer, X.
Published in
International Journal on Interactive Design and Manufacturing (IJIDeM)
Recent progress has been made in the field of digital processing tools based on interval analysis dedicated to decision support in embodiment design. In this paper, the performances of an interval analysis based Constraint Satisfaction Problem (CSP) solver and a Genetic Algorithm based design code are compared and discussed. The embodiment design p...
Sébastian, Patrick Chenouard, Raphael Nadeau, Jean-Pierre
International audience
