The increasing complexity of modulation schemes brought on by the evolution of mobile communication standards has led to high peak to average power ratio (PAPR) signals. As a result, traditional linear power amplifier (PA) architectures are no longer suitable as they exhibit low average efficiency when operating with such signals. One of the possib...
This paper discusses some of the design choices underlying the development of watt-level integrated Doherty power amplifiers in the K and Ka band, focusing on compound semiconductor technologies. The key aspect of on-chip power combination is discussed, presenting and comparing some of the possible alternatives. Then, the impact on the achievable b...
This letter presents the design and experimental characterization of a GaN-Si monolithic Doherty power amplifier (PA) for the Ka-band satellite downlink. The fabricated amplifier favorably compares with the current state of the art, achieving from 16.3 to 20.3 GHz (4 GHz, 22% relative bandwidth), a record band to date, 36.6-37.7-dBm output power, 2...
This article presents the design strategy and the implementation of a three-way Doherty power amplifier (DPA3W) to enhance the efficiency at deep power back-off. Theoretical design equations are derived, based on which design charts are drawn to explore the available design space, accounting for practical constraints related to the available techno...
This paper presents the linearity assessment of two state-of-the-art wideband power amplifiers, a single stage class AB and a two-way 6 dB Doherty, in terms of amplitude-to-phase-modulation (AM/PM) distortion. The simulated and measured characteristics are shown and discussed. The class AB amplifier maintains AM/PM within 6◦ from 1 to 4 GHz, i.e. o...
This letter presents a novel load-modulation-based 3rd-order intermodulation distortion (IMD3) cancellation technique for class-B CMOS power amplifiers (PAs). In a class-B PA, the IMD3 generated by the 3rd-order transconductance ( $g_{m3}$ ) and the gain compression have opposite signs, and thus, they can cancel each other at specific bias and load...
status: published
Les fortes capacités actuelles et envisagées des futurs liens satellites de communication pour la 5G conduisent les signaux traités dans les charges utiles à présenter simultanément d'importantes variations d'amplitude (PAPR>10dB) et de très larges bandes passantes instantanées (BW>1GHz). A l'intérieur du sous-système d'émission hyperfréquence, le ...
The objective of the proposed research is to identify the causes of signal bandwidth limitations of RF Power Transistors and develop a methodology to improve this capability beyond that which can be achieved using PCB tuning techniques. An RF power transistor will be developed that can amplify a wide-band signal in Class AB and Doherty Architecture...
This thesis presents a Doherty Radiator architecture that explores multi-feed antennas to achieve an on-antenna Doherty load modulation network and demonstrate high-speed high-efficiency transmission of wideband modulated signals. On the passive circuits, we exploit the multi-feed antenna concept to realize compact and high-efficiency on-antenna ac...
