In this study, we report the design and fabrication of a novel fluidic mixer. As proof-of-concept, the laminar flow in the main channel is firstly filled with small air-bubbles, which act as active stirrers inducing chaotic convective turbulent flow, and thus enhance the solutes mixing even at a low input flow rate. To further increase mixing effic...
Tato diplomová práce se zabývá možností využití technologie 3D tisku k výrobě tepelně izolačních panelů určených ke kontaktnímu zateplování budov. Důraz je kladen na stavby se zakřivenou fasádou, objevující se stále častěji v moderní architektuře. Práce je složena z teoretické částí, která obsahuje rešerši na technologie 3D tisku a úlohu této techn...
Published in Journal of Nanoparticle Research
Recent studies have reported emission rates of up to 1012 ultrafine particles/min from fused filament fabrication three-dimensional printers when operated in unventilated or minimally ventilated test chambers. However, in these studies, there are no data to relate this rate to airborne concentrations in a manufacturing environment. An assessment of...
Published in Journal of Orthopaedic Surgery and Research
BackgroundAdditively manufactured porous metallic structures have recently received great attention for bone implant applications. The morphological characteristics and mechanical behavior of 3D printed titanium alloy trabecular structure will affect the effects of artificial prosthesis replacement. However, the mechanical behavior of titanium allo...
There had been a paradigm shift in tissue engineering studies over the past decades. Of which, part of the hype in such studies was based on exploring for novel biomaterials to enhance regeneration. Strontium ions have been reported by others to have a unique effect on osteogenesis. Both in vitro and in vivo studies had demonstrated that strontium ...
Published in 3D Printing in Medicine
An anthropomorphic phantom is a radiologically accurate, tissue realistic model of the human body that can be used for research into innovative imaging and interventional techniques, education simulation and calibration of medical imaging equipment. Currently available CT phantoms are appropriate tools for calibration of medical imaging equipment b...
In this paper, the influence of layer thickness (LT), infill percentage (IP), and extruder temperature (ET) on the maximum failure load, thickness, and build time of bronze polylactic acid (Br-PLA) composites 3D printed by the fused deposition modeling (FDM) was investigated via an optimization method. PLA is a thermoplastic aliphatic polyester obt...
New technologies are offering progressively more effective alternatives to traditional ones. Additive Manufacturing (AM) is gaining importance in fields related to design, manufacturing, engineering and medicine, especially in applications which require complex geometries. Fused Deposition Modelling (FDM) is framed within AM as a technology in whic...
Published in Disability and rehabilitation. Assistive technology
Objective: Despite immense popularity of Jaipur foot as low cost prosthetic, not much work has been reported on its design for manufacturing standardization. Without manufacturing standardization, it cannot be mass produced using contemporary manufacturing technologies. The objective of this work is to carry out its computer aided design (CAD) foll...
Published in SLAS technology
Typography-like templates for polydimethylsiloxane (PDMS) microfluidic chips using a fused deposition modeling (FDM) three-dimensional (3D) printer are presented. This rapid and fast proposed scheme did not require complicated photolithographic fabrication facilities and could deliver resolutions of ~100 μm. Polylactic acid (PLA) was adopted as the...
