Published in Mechanics & Industry
After the lean fuel premixed combustion technology is applied to aero engines, severe combustion oscillations will be cased and led to hidden safety hazards such as engine vibration, further energy waste and other problems. Therefore, it is increasingly important to actively control combustion oscillations. In this paper, a multispectral radiation ...
Published in Mechanics & Industry
This paper presented a new control strategy for active suspension of nonlinear quarter-vehicle model. An active suspension controller designed for using sliding mode control with noise filtering. The Kalman filter (KF) predicted the state response of the nonlinear one-quarter automobile model, and the estimated values used for the design of the act...
Published in Mechanics & Industry
Microwave cutting glass and ceramics based on thermal controlled fracture method has gained much attention recently for its advantages in lower energy-consumption and higher efficiency than conventional processing method. However, the irregular crack-propagation is problematic in this procedure, which hinders the industrial application of this adva...
Published in Mechanics & Industry
The conceptual design is a crucial phase for the System Architects to evaluate 3D architecture concepts of mechatronic systems mainly with regard to the ElectroMagnetic Compatibility (EMC). Our research work deals with the combination of electromagnetic modeling and a topological approach to support the qualitative and quantitative ElectroMagnetic ...
Published in Mechanics & Industry
Many sources of heat can emanate from the operation of a rotating machine, and one of which is the friction among the different parts of the ball bearings. Over time, these frictions may lead to a tearing of matter of the rings or on the rolling elements that cause some type of degradation by flaking. Flaking, in turn, produces a repetitive shock a...
Published in Mechanics & Industry
The knowledge of the service life of polymers under cyclic loading, widely used in industrial applications, is required and usually based on the use of methods necessitating an accurate prediction of the stabilized cycle. This implies a large computation time using the Finite Element Method (FEM) since it requires a large number of cycles for polym...
Published in Mechanics & Industry
This paper concerns the experimental and numerical study of the plug-assisted thermoforming process of high impact polystyrene (HIPS). The thermomechanical properties of this polymer were characterized at different temperatures and deformation rates. To study the influence of different parameters in the real conditions of plug-assisted thermoformin...
Published in Mechanics & Industry
Generation of total heat in hard turning largely influenced the cutting tool wear, tool life and finishing quality of work-surface. Thus, the measurement of this heat in terms of temperature becomes a necessity for achieving favourable machining performances. Therefore, this work presents a novel study on temperature measurement in three different ...
Published in Mechanics & Industry
In this paper, a new analytical approach to object oriented modeling is presented for the predesign of a multibody system. We investigate the dynamic behavior of a system of interconnected components using the modeling language Modelica. In engineering, beam-masses are often used as design models. In fact, the considered system is composed of a fle...
Published in Mechanics & Industry
Herringbone planetary gear system (HPGS) has high power density and complex structure. The torsional flexibility of the left and right teeth of the sun gear is closely related to the dynamic characteristics of the HPGS. In this research, considering the coordination conditions of both sides torsional stiffness and axial slide of the sun gear, a new...
